Akai EWI4000s

Photo: Bubli (Wikimedia Commons) · CC BY-SA 3.0 ↗

Akai · Synthesizer

Akai EWI4000s

The Akai EWI4000s is an electronic wind instrument: a wind controller with an internal sound module. Breath pressure, lip pressure, touch-sensitive keys, bend and glide plates and octave rollers drive a built-in analog-modelling synthesizer with two oscillators (saw, triangle, pulse), two filters, a noise generator, a formant filter and reverb, delay and chorus. It holds 100 programs, plays one note at a time (two with the Octave and Hold functions), and offers EWI, saxophone, flute, oboe and EVI fingerings. It runs on four AA batteries or an optional adaptor and has a line output and headphone jack, so it can be played without other gear, while MIDI In and Out let it drive external sound modules. The EWI4000s exchanges its sound data as manufacturer System Exclusive messages. There is no dump button on the instrument: the UniQuest editor and librarian reads the whole internal preset bank from it, sends single presets to its edit buffer and writes a complete bank back to its flash memory. Saved banks can also be exported as MIDI files that replay the bank into any EWI4000s. Firmware updates are also loaded over MIDI from a computer.

SysEx messages

0 files

This instrument is still waiting for its first SysEx.

If you own one, or can recover a dump from an old disk or backup, upload it here: every message helps the library and the community grow.

Upload a SysEx

SysEx guide

Manufacturer ID
47
Default device ID
SysEx ID 0 (the EWI's MIDI channel minus 1; MIDI channel 1 by default)

Receiving a dump

No special mode is needed for editor traffic. Connect EWI MIDI Out to the computer's MIDI In and the computer's MIDI Out to EWI MIDI In, and disable SysEx filtering on the MIDI interface. If SysEx transfers fail, change the CP (Control Protocol) setting in the Setup menu.

Sending a dump from the instrument

No front-panel dump is documented. Use the editor: select Preset Bank and click Get; the bank uploads from the EWI in about 12 seconds.

Requesting a dump

The UniQuest editor requests the internal preset bank (Get) and writes a bank back to flash memory (Put); single presets are sent to the edit buffer. The message format is not published in the documents opened.

SysEx pitfalls

The editor's SysEx channel (Comm Ch) must be one less than the EWI's MIDI channel. The CP menu is described differently in two Akai documents: the Reference Manual says it is on by default, adds an extra SysEx check and should be set off if problems occur, while the v2.4 software history says ON enables an alternate receive mode recommended when receiving fails. For firmware files Akai recommends a 200-300 ms pause between messages in SysEx Librarian.

Source: UniQuest for EWI 4000s Quick Start pp. 1-8 and 32-33; EWI4000s Reference Manual Rev D pp. 35, 43, 46 ↗

Specifications

Synthesis
Analog modelling synthesizer with noise generator and formant filter
Polyphony
1 note; 2 with the Octave and Hold functions
Oscillators
2 oscillators per program (saw, triangle, pulse)
Filter
2 filters plus formant filter
Memory
100 programs
Keyboard / format
Wind controller with touch-sensor keys, breath and lip sensors; EWI, saxophone, flute, oboe, EVI and EVI reversed fingerings
Outputs
1 line out (1/4 inch), 1 headphone out
MIDI
MIDI In, MIDI Out (5-pin DIN)

Known issues and maintenance

Firmware 2.4 cannot be downgraded. Version 2.4 fixed patches received incorrectly over MIDI, which caused corrupted patches and 88 on the display at start-up. Factory reset: power on while holding LEVEL, FX, SETUP and TRANS.

Sources

to be verified

These notes have not been checked against the sources yet. Corrections are welcome in the comments.

  1. Akai EWI4000s Reference Manual Rev D ↗ — Features p. 4, factory reset p. 33, software update p. 35, MIDI chart p. 43, CP menu p. 46, specifications p. 47
  2. UniQuest for EWI 4000s Quick Start (Akai) ↗ — SysEx communication, Comm Ch rule, preset bank get and put, exports
  3. Akai EWI4000s Software History ↗ — Firmware versions from December 2005 to v2.4 (November 2008), CP menu, MIDI receive fixes
  4. EWI4000s Manual Addendum v2.3 ↗ — New menus and fingering modes of firmware 2.0 to 2.3

Comments

0

Sign in to write a comment.

An unhandled error has occurred. Reload 🗙

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.