no image yet
Digitech · Effect Processor · 1992

Digitech RP-1

The DigiTech RP-1 is a floor-standing guitar multi-effects processor, preamp and MIDI foot controller from the early 1990s. DigiTech described it as rack-quality processing packed into a pedalboard: it offers 24 effects, up to nine at once, including compression, distortion, graphic EQ, noise gate, delay, reverb and a speaker simulator, plus a programmable effects loop and an infinite Repeat Hold mode. The unit holds 75 user programs, with programs 76 to 150 keeping fixed copies of the factory sounds. Its footswitches work in five-patch or ten-patch modes, grouped in Sets, and can also switch individual effects. On the rear panel are an audio input, left and right outputs, a headphone output, effects send and return, and MIDI In, Out and Thru, so the RP-1 can also send program changes to other MIDI gear. The MIDI chart marks System Exclusive as transmitted and recognized. From the MIDI Setup menu in Utility the RP-1 can dump its entire memory, for backup or to copy all programs to another RP-1, or send a single program under a different program number so it does not overwrite the receiver's own sound.

SysEx messages

0 files

This instrument is still waiting for its first SysEx.

If you own one, or can recover a dump from an old disk or backup, upload it here: every message helps the library and the community grow.

Upload a SysEx

SysEx guide

Manufacturer ID
00 00 10

Receiving a dump

1. In Utility, MIDI Setup Menu, set RP-1 MIDI CHANNEL to the sender's channel or ALL CHANNELS. 2. Send the dump to MIDI In; the manual gives no further receive step.

Sending a dump from the instrument

1. Connect the RP-1 MIDI Out to the receiving device. 2. In Utility, MIDI Setup Menu, scroll to DUMP MIDI DATA? (display: PRESS down FOR YES). 3. Press the DOWN parameter button; the display shows MIDI DATA DUMP COMPLETE. 4. For one program: scroll to DUMP PROGRAM, pick the program with UP/DOWN and press RIGHT, pick the target number under AS and press RIGHT, then press DOWN.

SysEx pitfalls

A single program received into an occupied number replaces it, so choose the target number with the AS option. The byte format is not in the manual; Appendix C refers to DOD Electronics for the DOD/DigiTech System Exclusive Format.

Source: DigiTech RP-1 Owner's Manual 18-0159-C (1992), pp. 21-22, Appendices B and C ↗

Specifications

Memory
150 programs: 1-75 user, 76-150 fixed factory copies
Keyboard / format
Floor unit with footswitches
Outputs
Left and right outputs, headphone output, effects send and return
MIDI
MIDI In, MIDI Out, MIDI Thru

Known issues and maintenance

Backup battery is a lithium cell; the manual specifies Eveready CR 2032 or equivalent.

Sources

to be verified

These notes have not been checked against the sources yet. Corrections are welcome in the comments.

  1. DigiTech RP-1 Owner's Manual, part no. 18-0159-C, copyright 1992, printed 5/93; scanned PDF read as page images ↗ — Quick start p. 3, introduction and battery note p. 4, MIDI dumps pp. 21-22, footswitch setup and factory restore pp. 22-23, program list, MIDI chart and SysEx format appendix
  2. DigiTech Product Manuals page ↗ — Lists the RP1 owner's manual

Comments

0

Sign in to write a comment.

An unhandled error has occurred. Reload 🗙

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.