#2081 · All Data Dump
another test
The Ensoniq ESQ-M is a rack-mount digital wave synthesizer module. Its manual presents it as the sounds and multitimbral abilities of the ESQ-1 keyboard in a two-space rack, without the ESQ-1's sequencer. It plays eight voices. Each voice has three digital oscillators that choose among 32 sampled and synthetic waveforms, followed by an analog four-pole low-pass filter with resonance, three LFOs and four envelopes. The module keeps 40 programs in battery-backed memory and reads 80 more from a cartridge. Nine tracks, each with its own program, MIDI channel and level, let it answer on nine MIDI channels at once, and an overflow mode passes extra notes to a second unit. Ensoniq states that all ESQ-1 sounds play on the ESQ-M and the other way round. Over System Exclusive the ESQ-M sends and receives a single program (102 bytes of data) or the whole bank of 40 internal programs, both started from the Storage page. The manual describes these transfers as going to another ESQ-M, an ESQ-1 or a computer. With System Exclusive enabled, an ESQ-1 or a computer can also edit the module's parameters remotely.
Sign in to upload or commentIf you own one, or can recover a dump from an old disk or backup, upload it here: every message helps the library and the community grow.
Upload a SysExRelated models: ESQ-1
According to the ESQ-M Musician's Manual, the ESQ-M exchanges programs with the ESQ-1.
1. Press Param, then the MIDI page button. 2. Press Scroll until the display shows ENBL=. 3. With the Up Arrow button set ENBL=KCPSYS (keys, controllers, program changes and System Exclusive). 4. Set the same Base MIDI Channel as the sender. 5. Leave the ESQ-M on a program page (program select mode). The setting returns to K+C+PC at the next power-up.
All 40 internal programs: 1. Press Param and select the Storage page. 2. Press Scroll until the display shows BANK TO MIDI. 3. Hold Scroll and press Storage. The display shows MIDI DATA XFER for about 3 seconds, then DATA XFER DONE. Current program: the Storage page opens on PROG TO MIDI; the program is sent to the edit buffer of the receiver.
The MIDI implementation in the manual lists no dump request message. It documents single and all program dumps, virtual keypad events, the Compare status message and the reply to a MIDI Device Inquiry.
Header: F0 0F 02 0n, where n is the base MIDI channel; the ESQ-M ignores messages on another channel. Message type 01 is a single program, 02 all 40 programs. Each program is 102 bytes and each byte travels as two MIDI bytes, low nybble first. A received bank replaces all 40 internal programs. A received single program goes to the edit buffer and must be written from the front panel. Set ENBL back to K+C+PC afterwards, or the module keeps following the data slider and buttons of the master keyboard.
Source: Ensoniq ESQ-M Musician's Manual, printed pp. 35-36, 86-87 and 108-111
Internal battery. Programs are kept in battery-backed RAM. The manual gives the battery a life of up to ten years and says only an authorized Ensoniq repair station should replace it. When it runs down the display shows BATTERY VOLT LOW at power-up: save the programs to a cartridge or a computer first. On the Analog Test page B=00 means the battery is good.
These notes have not been checked against the sources yet. Corrections are welcome in the comments.
Sign in to write a comment.
Comments
0