#1447 · Single Patch Data Dump
a lot of patches
The Kawai K1r is a one-unit rack version of the K1 digital synthesizer. It has the same sound engine as the keyboard model and the K1m tabletop module, without the joystick. Reviews of it appeared in British magazines in spring and summer 1989. Each single patch mixes up to four sources. A source plays one of 256 waveforms: 204 are short digital waveforms that Kawai calls VM, built by additive synthesis, and 52 are PCM samples, mostly attacks and loops of real instruments and drums. Pairs of sources can also modulate each other (ring modulation). The K1r plays up to 16 voices, and a multi patch combines up to eight single patches, each on its own MIDI channel, so the module can cover several parts of a sequence. Reviewers praised its ease of use and its sound; Phaze 1 wrote that it has "a pleasing sonic character". The internal memory holds 64 single and 32 multi patches, and an optional DC-8 card holds as many again. Over MIDI the K1r sends one tone patch or one block of 32 tone patches as System Exclusive data, and the manual states that these dumps can go to another K1, K1m or K1r. Reception must be enabled on the receiving unit.
Sign in to upload or commentIf you own one, or can recover a dump from an old disk or backup, upload it here: every message helps the library and the community grow.
Upload a SysExThe K1r owner's manual says it sends tone patch data to another K1, K1m or K1r.
1. Press SYSTEM and change the display from SYS to RCV. 2. Press SYSTEM repeatedly until RCV-11 EXCL appears and set it to ON. 3. In the SYSTEM parameters set INT PROTECT to OFF (CARD PROTECT to OFF if the data must go to a card).
1. Connect MIDI OUT of the K1r to MIDI IN of the receiver. 2. Select the tone patch, or a patch of the block, that you want to send. 3. Press SYSTEM and move to the DATA DUMP display (TRS-4). 4. With +YES/-NO choose PACH (one tone patch) or BLOK (one block of 32 tone patches). 5. Press SYSTEM: the display asks EXEC? 6. Press +YES to send (COMPLETED) or -NO to cancel (CANCELED).
The receiving unit must have RCV EXCL set to ON and the memory protection OFF, otherwise the data is not stored. The front panel sends one patch or one block of 32 patches at a time.
Source: Kawai K1r Owner's Manual, viewer pp. 38-42 of the copy hosted by ManualsLib
A lithium battery keeps the memory. Kawai gives it a life of more than five years in normal use and recommends replacement by an authorised service centre after five years. Save the internal patches to a card before any repair: the manual warns that they may be lost during testing. If the unit locks up because of mains noise, switch it off for a few seconds and on again. Error messages: PROTECTED (write protection is on for the destination), NO CARD, ID ERROR (the card is not formatted for the K1r).
These notes have not been checked against the sources yet. Corrections are welcome in the comments.
Sign in to write a comment.
Comments
0