no image yet
Oberheim · Synthesizer · 1985

Oberheim Matrix-12

The Oberheim Matrix-12 is a 12-voice analog keyboard synthesizer that reached the market in 1985. It gives the voice of the six-voice Xpander module twice the polyphony and a 61-note keyboard that senses velocity, release velocity and pressure. Each voice has two VCOs, a filter with 15 modes, five envelopes, five LFOs, three tracking generators, four ramp generators and a lag processor. The Matrix Modulation system connects 27 sources to 47 destinations. Every voice can play its own sound: a Multi Patch assigns a Single Patch to each voice and spreads the voices over six keyboard zones or separate MIDI channels. Oberheim today calls the Matrix-12 its "most ambitious and versatile synth". Reviewing it in 1985, Simon Trask of Electronics & Music Maker missed the Xpander's individual outputs and CV inputs. The memory holds 100 Single Patches and 100 Multi Patches. With System Exclusive enabled, the instrument sends one Single Patch to a chosen location of the receiver, or its whole memory in about 20 seconds; Multi Patches travel only in the complete dump. According to the manual, Single Patches are exchanged exactly with the Xpander, while Multi Patches are converted on the way.

Sign in to upload or comment

SysEx messages

0 files

This instrument is still waiting for its first SysEx.

If you own one, or can recover a dump from an old disk or backup, upload it here: every message helps the library and the community grow.

Upload a SysEx

From compatible models

Oberheim Xpander / Matrix-12

Related models: Xpander

The Matrix-12 owner's manual (p. 80): single patches transfer in both directions; the Xpander needs voice software 1.3 or higher.

SysEx guide

Manufacturer ID
10
Default device ID
None: System Exclusive is not tied to a MIDI channel

Receiving a dump

1. Switch Memory Protect off. 2. Press MASTER PAGE, select MIDI in the upper display, then ENABLES. 3. Select SYSTEMX so that it is underlined (on). 4. Send the data. A single patch is stored in the destination number chosen on the sender.

Sending a dump from the instrument

1. Connect MIDI Out to the receiver's MIDI In. 2. For one patch, select the Single Patch with the keypad. 3. Press MASTER PAGE, select MIDI, then ENABLES, and turn SYSTEMX on (on the receiver too). 4. Press MASTER PAGE, select MIDI, then SEND: the upper display reads SEND CURRENT PATCH TO MIDI. 5. Set DESTINATION PATCH with knob 4 or the X SELECT buttons. To send the whole memory turn knob 4 fully counter-clockwise until the destination reads ALL. 6. Press START. One patch takes less than a second, the whole memory about 20 seconds (the display shows SENDING).

SysEx pitfalls

Multi Patches cannot be sent one at a time: they are sent only with ALL, together with the Single Patches they refer to. If Memory Protect is on, the display shows MEMORY PROTECTED and the incoming data is ignored. With SYSTEMX on at both ends, edits made on one instrument are also applied on the other. Transfers between two Matrix-12s are exact. With an Xpander, Single Patches transfer exactly, Multi Patches are converted (voices 1-6 are copied to voices 7-12), and the Xpander needs voice software revision 1.3 or higher to accept Matrix-12 patches.

Source: Oberheim Matrix-12 Owner's Manual, First Edition, September 1986 (part no. 950039), pp. 16, 59-61, 65-66 and 80

Specifications

Synthesis
Analog subtractive synthesis with oscillator FM and matrix modulation (27 sources, 47 destinations)
Polyphony
12 voices
Multitimbrality
Each voice can play its own Single Patch; voices are assigned to six keyboard zones or to separate MIDI channels (up to 12)
Oscillators
2 VCOs per voice, plus a noise generator
Filter
1 VCF per voice with 15 modes
Memory
100 Single Patches and 100 Multi Patches
Keyboard / format
61 keys, non-weighted, with velocity, release velocity and pressure
Outputs
Stereo left and right outputs with seven pan positions per voice, plus a mono output; no individual voice outputs
MIDI
In, Out, Thru

Known issues and maintenance

Memory Protect: when the switch is on nothing can be stored, cassette loads are refused and incoming MIDI patch data is ignored. On the unit reviewed in 1985 keyboard pressure worked only over MIDI; Oberheim promised a free retrofit. Oberheim service centres could retrofit newer software revisions to any Matrix-12.

Sources

to be verified

These notes have not been checked against the sources yet. Corrections are welcome in the comments.

  1. Oberheim Matrix-12 Owner's Manual, First Edition, September 1986 (part no. 950039) — Specifications, Memory Protect, MIDI enables, sending patches over MIDI, data compatibility with the Xpander. Copy hosted by ManualsLib, not by Oberheim.
  2. Simon Trask, "Oberheim Matrix 12", Electronics & Music Maker, June 1985 ↗ — Launch review: relation to the Xpander, patch memory, outputs, missing CV inputs and individual outputs, pressure retrofit, UK price
  3. Oberheim: About ↗ — The manufacturer's present-day description of the Matrix 12 and its matrix modulation
  4. Simon Lowther, "Oberheim Xpander" (Retrozone), Sound On Sound, January 1998 ↗ — The Matrix 12 followed the Xpander by nearly a year and shares its voice

Comments

0

Sign in to write a comment.

An unhandled error has occurred. Reload 🗙

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.