no image yet
Roland · Effect Processor · 1989

Roland GS-6

The Roland GS-6 Digital Guitar Sound System is a one-unit rack guitar preamplifier with built-in effects, documented in a 1989 owner's manual. A guitar plugged into the front passes through a digitally controlled preamp with eight overdrive types and an equaliser, then hum cancel and a noise suppressor, and finally reverb, delay and chorus, which can run together. Conversion is 16-bit at 32 kHz. It has unbalanced jack outputs and balanced XLR line outputs, and can be switched from MIDI to Roland's FC-100 foot controller. The unit stores 64 patch memories, arranged in eight banks of eight, each holding the preamp settings and the state of every effect. All 64 patches can be sent as a System Exclusive bulk dump to another GS-6 or to a sequencer, by holding WRITE in MIDI mode, and loaded back the same way. Single patches and the edit buffer can also be read and written with Roland's request and data set messages, which the manual documents with a full address map.

SysEx messages

0 files

This instrument is still waiting for its first SysEx.

If you own one, or can recover a dump from an old disk or backup, upload it here: every message helps the library and the community grow.

Upload a SysEx

SysEx guide

Manufacturer ID
41
Model ID
26
Default device ID
MIDI channel minus 1 (channel 1 = device ID 00)
Suggested delay between messages
20 ms

Receiving a dump

1. Set the GS-6 to the same MIDI channel as the sender. 2. Press MIDI/EFF COPY so that its indicator lights (MIDI setting mode). 3. The unit now receives at any time; the display shows bLd. If it shows Err, press MIDI/EFF COPY and repeat.

Sending a dump from the instrument

1. Set the same MIDI channel on the GS-6 and on the receiver. 2. Press MIDI/EFF COPY so that its indicator lights. 3. Hold WRITE for more than one second. The display shows bdP and the 64 patch memories are sent.

Requesting a dump

RQ1: F0 41 dev 26 11, 2-byte address, 2-byte size, checksum, F7. Valid for the temporary area (00 00), hum cancel (04 00), noise suppressor (0A 00) and single patch memories (10 00 to 1F 60, size 00 20). The bulk data banks (20 00 to 2E 00) cannot be requested. The GS-6 answers with DT1 (12H).

SysEx pitfalls

The bulk dump is 8 DT1 messages, one per bank, more than 20 ms apart. Checksum: address, data and checksum must sum to 0 in the lower 7 bits. Addresses 40 00 to 40 30 trigger write and effect copy operations.

Source: Roland GS-6 Owner's Manual, Data Transfer via MIDI pp. 28-29, MIDI Implementation pp. 38-39, MIDI Implementation Chart p. 45 ↗

Specifications

Synthesis
Digital guitar preamp (8 drive types, EQ) with reverb, delay, chorus, noise suppressor and hum cancel; 16-bit, 32 kHz
Memory
64 patch memories (8 banks x 8)
Keyboard / format
1U rack module
Outputs
Output jacks A (mono) and B; balanced XLR line outs A and B
MIDI
In, Out (In shared with RRC IN by a select switch)

Known issues and maintenance

An internal battery keeps the patch memory; Roland recommends replacing it every five years via a service station (owner's manual p. 4). Factory presets 11-48 are restored by switching on while holding the down and right buttons, then pressing WRITE while FP is shown (p. 30).

Sources

to be verified

These notes have not been checked against the sources yet. Corrections are welcome in the comments.

  1. Roland GS-6 Digital Guitar Sound System Owner's Manual (1989), scanned PDF read as page images ↗ — Features and contents p. 3, battery p. 4, structure p. 5, MIDI parameters p. 26, bulk dump pp. 28-29, factory reset p. 30, MIDI implementation pp. 38-39 (Dec. 27 1988), specifications p. 42, MIDI chart p. 45

Comments

0

Sign in to write a comment.

An unhandled error has occurred. Reload 🗙

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.