Roland R-5
The Roland R-5 Human Rhythm Composer is a 1989 drum machine and the smaller companion of the R-8. It plays 68 instrument sounds sampled at 44.1 kHz, with 26 extra slots for edited copies, from 16 touch-sensitive pads. Each sound can be tuned, shortened, given a nuance that changes how hard a drum is struck or where a cymbal is hit, and sent to one of four individual outputs or a position in the stereo mix. Its headline feature is the Feel Patch: eight stored sets of groove and random variations of velocity, pitch, decay and nuance that make programmed patterns sound less mechanical. It holds 32 preset and 100 programmable patterns and six songs. Music Technology described it as the R-8's little brother, with most of its features at a lower price. The R-5 can send a System Exclusive bulk dump of all its data, of patterns and songs only, of its setup (sounds, assignments, feel patches and MIDI settings) or of a single pattern, and it loads such dumps back when its exclusive receive switch is on.
SysEx messages
0 filesThis instrument is still waiting for its first SysEx.
If you own one, or can recover a dump from an old disk or backup, upload it here: every message helps the library and the community grow.
Upload a SysExSysEx guide
- Manufacturer ID
- 41
- Model ID
- 2C
- Default device ID
- Basic channel minus 1 (channel 1 = device ID 00)
Receiving a dump
1. Set the R-5 basic channel (Instrument Section receive channel) to the sender's channel. 2. Press MIDI, then numeric key 3 (FNC SW). 3. Press SELECT until EXCLSV RX is shown and set it ON with +1/ON. 4. Press EXIT. With play stopped, the R-5 receives at any time and shows BULK LOAD Receiving.
Sending a dump from the instrument
1. Set the same basic channel on the R-5 and the receiver. 2. Press MIDI, then numeric key 4 (DUMP). 3. Choose 1 ALL, 2 SEQ (patterns and songs), 3 SETUP (instrument assign, sound, performance, feel patches, MIDI, metronome, sync) or 4 1 PTN (then pick the pattern with -1/OFF and +1/ON). 4. Press ENTER; Are you sure? appears. 5. Press ENTER again. Completed is shown at the end.
Requesting a dump
The manual lists RQ1 (F0 41 dev 2C 11, 4-byte address, 4-byte size, checksum, F7) but names only two cases in which the R-5 transmits: a bulk dump started on the panel and ENTER in Sound Edit.
SysEx pitfalls
If pattern memory fills during reception the display shows Ptn mem full and reception stops: clear patterns or send less data. Exclusive messages are not received while the sequencer runs or with EXCLSV RX off. ENTER in Sound Edit also sends the edited sound's parameters.
Specifications
- Synthesis
- PCM samples (44.1 kHz, 16-bit dynamic range) with pitch, decay and nuance per instrument
- Oscillators
- 68 internal instrument voices plus 26 Copy Instruments
- Memory
- 32 preset and 100 programmable patterns (2,600 notes), 6 songs, 8 Feel Patches; tape storage
- Keyboard / format
- Tabletop drum machine with 16 touch-sensitive pads
- Outputs
- Multi outputs 1-4, stereo out L and R/mono, headphones
- MIDI
- In, Out, Thru
Known issues and maintenance
An internal battery keeps the memory; Roland recommends replacing it every five years via a service station and saving important data on tape (owner's manual p. 7). Factory reset: hold SELECT and PAGE while switching on, then press ENTER twice (guidebook p. 5).
Sources
to be verifiedThese notes have not been checked against the sources yet. Corrections are welcome in the comments.
- Roland R-5 Human Rhythm Composer Guidebook and Owner's Manual (1989), scanned PDF read as page images ↗ — Battery p. 7, features p. 10, exclusive switch p. 150, bulk dump and reception pp. 151-153, MIDI implementation pp. 202-203, MIDI chart p. 206, specifications pp. 208-209; guidebook initialisation p. 5
- Nigel Lord, "Roland R5: Human Rhythm Composer", Music Technology, July 1989 ↗ — Review: comparison with the R8, feel parameters, outputs, price, verdict
Sign in to write a comment.
Comments
0