no image yet
Roland · Synthesizer · 2000

Roland XV-88

The Roland XV-88 is an 88-key synthesizer released in 2000. It puts the sound engine of the XV-3080 rack module into a fully weighted keyboard with aftertouch: 128 voices, 16 parts and 64 MB of sampled waveforms, with patches built from up to four tones, each with its own filter and amplifier. It holds 768 preset patches plus 256 General MIDI 2 sounds, 128 user patches, 64 user performances and 4 user rhythm sets, and saves to SmartMedia cards. Four slots take two SR-JV80 and two of the then new SRX wave expansion boards. A D Beam controller, four sliders, an arpeggiator and 16 keyboard zones make it a master keyboard as well. Sound On Sound called it an excellent weighted master keyboard containing the powerful XV-3080 synth, while noting a slow key return and channel aftertouch only. The XV-88 can save its user memory as System Exclusive bulk dumps from the UTILITY transfer page: performances, patches and rhythm sets together or separately, the system settings, or the sound being edited. The dumps use Roland's model ID 00 10, the same as the XV-3080 and XV-5080, and the address map is printed as one table for the three models. They can also be requested from a computer.

SysEx messages

0 files

This instrument is still waiting for its first SysEx.

If you own one, or can recover a dump from an old disk or backup, upload it here: every message helps the library and the community grow.

Upload a SysEx

SysEx guide

Manufacturer ID
41
Model ID
00 10
Default device ID
Device ID 17 at the factory (dev byte 10H); range 17-32
Suggested delay between messages
20 ms

Receiving a dump

1. SYSTEM > MIDI > SYSTEM MIDI: set Rx Sys.Excl to ON (factory setting ON). 2. On the same page set Device ID to the value used when the dump was made. 3. UTILITY > 5. PROTECT: set Exclusive Protect to OFF so that SysEx can overwrite the user memory. 4. Send the file to MIDI IN (or to the Computer connector when the COMPUTER switch is set to Mac or PC).

Sending a dump from the instrument

1. Press [UTILITY] to reach the UTIL 1 page. 2. Select 4. XFER and press [ENTER]: the TRANSFER TO MIDI page appears. 3. With the cursor and the VALUE dial set Type (ALL, PERFORM, PATCH, RHYTHM or SYSTEM), Block (USER or TEMP) and, if needed, the range, e.g. PATCH USER:001-128. ALL sends performances, patches and rhythm sets. 4. Start the recorder and press [ENTER]. The display shows Executing..., then COMPLETED. [EXIT] stops the transfer.

Requesting a dump

Send a Roland data request RQ1: F0 41, device ID, 00 10 11, a 4-byte address, a 4-byte size, checksum, F7. Addresses: 00 00 00 00 system, 20 00 00 00 to 20 3F 00 00 user performances, 30 00 00 00 to 30 7F 00 00 user patches, 40 00 00 00, 40 10 00 00, 40 20 00 00 and 40 30 00 00 user rhythm sets, 10 00 00 00 temporary performance. RQ1 is ignored when Rx Sys.Excl is OFF.

SysEx pitfalls

A different device ID or Rx Sys.Excl OFF makes the unit ignore the data; Exclusive Protect ON blocks writes to the user memory. Data over 256 bytes is sent in packets about 20 ms apart. Addresses valid only on the XV-3080 or XV-5080 are ignored by the XV-88.

Source: Roland XV-88 Owner's Manual pp. 166, 171, 185-188, 216, 275-279 ↗

Specifications

Synthesis
PCM sample playback (XV-3080 engine): up to 4 tones per patch, each with filter and amplifier
Polyphony
128 voices
Multitimbrality
16 parts
Oscillators
64 MB wave memory; up to 4 tones per patch; 2 SR-JV80 and 2 SRX expansion slots
Filter
One per tone: LPF, BPF, HPF, peaking, LPF2, LPF3 or off
Memory
128 user patches, 64 user performances, 4 user rhythm sets; 768 preset patches plus 256 GM2; SmartMedia card
Keyboard / format
88 keys, fully weighted, velocity and channel aftertouch
Outputs
Mix out L/R, outputs B L/R (individual 1-4), headphones
MIDI
MIDI In, Out, Thru; Computer serial connector (Mac, PC, MIDI)

Known issues and maintenance

An internal battery keeps the user memory; the UTILITY battery check shows OK or LOW, and a low-battery message asks for replacement by a Roland service centre. Internal Write Protect turns on again at every power-on.

Sources

to be verified

These notes have not been checked against the sources yet. Corrections are welcome in the comments.

  1. Roland XV-88 Owner's Manual (2000), with MIDI implementation ↗ — Specifications p. 298, bulk dump pp. 166 and 185-186, Rx Sys.Excl and device ID p. 171, protect p. 188, model ID and address map pp. 275-279
  2. Roland XV-3080 Owner's Manual ↗ — Same model ID 00H 10H in its MIDI implementation
  3. Roland XV-5080 Owner's Manual ↗ — Same model ID 00H 10H in its MIDI implementation
  4. Gordon Reid, "Roland XV88", Sound On Sound, January 2001 ↗ — Review: XV-3080 engine, expansion slots, keyboard criticisms, verdict

Comments

0

Sign in to write a comment.

An unhandled error has occurred. Reload 🗙

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.