Yamaha MU90
The Yamaha MU90 is a desktop XG tone generator, the half-width sibling of the rack MU90R. Its AWM2 engine plays 64 notes across 32 parts, received on two MIDI inputs or through the TO HOST serial port, and it keeps TG300B and C/M modes for older song files. The specifications list 779 voices and 30 drum programs, 100 preset and 100 user Performances, and an effects section with reverb, chorus, variation, two insertion effects and EQ. A front A/D input brings a microphone or instrument into the unit as its own A/D part. Yamaha supplied the MU90 with the MU90R owner's manual and data booklet, because the two units work almost the same way; only the MU90R output selection features and the identity reply byte differ. The Dump Out menu sends All data, Multi settings for 16 or 32 parts with or without the A/D parts, or the user Performances. XG bulk dumps (model ID 4C) carry the XG system, effect, EQ, multi part, A/D part and drum setup blocks. The system data and the older MU80/MU50 Performance format use model ID 49, and the MU90 Performances use model ID 59. Multi settings are not stored in the unit, so a dump is the only way to keep them.
SysEx messages
0 filesThis instrument is still waiting for its first SysEx.
If you own one, or can recover a dump from an old disk or backup, upload it here: every message helps the library and the community grow.
Upload a SysExSysEx guide
- Manufacturer ID
- 43
- Model ID
- 4C (XG), 49 and 59 (native)
- Default device ID
- Device Number 1-16 or all (factory value not stated)
Receiving a dump
1. Press UTIL and open the System functions. 2. Set Receive System Exclusive (RcvSysExcl) to on. 3. Set the Device Number to match the dump, or to all.
Sending a dump from the instrument
1. Connect MIDI OUT to the recorder and set HOST SELECT to MIDI, or use TO HOST. 2. Press UTIL, select DUMPOUT and press ENTER. 3. Choose All, Multi (32 Parts, 16 Parts, 32 Parts + A/D, 16 Parts + A/D) or Performance (ALL or I001-I100) and press ENTER. 4. Press ENTER at Are you sure?; Transmitting... appears.
Requesting a dump
XG dump request F0 43 2n 4C hh mm ll F7; native requests use model ID 49 or 59 in the same layout. The address must be the start of a block and the reply is a bulk dump. Requests can only be blocked by setting Exclusive off.
SysEx pitfalls
Bulk dumps carry byte count, address and checksum. System Information is sent only in reply to a request and ignored on reception. Dump Interval (50-300) sets the pause between blocks; raise it if the receiver reports buffer full. XG System On needs about 50 ms. The MU90 answers an identity request with 37H where the MU90R booklet prints 52H.
Specifications
- Synthesis
- AWM2 (Advanced Wave Memory 2) sample playback; XG, TG300B, C/M and Performance modes
- Polyphony
- 64 notes
- Multitimbrality
- 32 parts on 32 MIDI channels (MIDI IN-A and IN-B, or TO HOST)
- Memory
- 779 voices and 30 drum programs in ROM; Performances: 100 preset and 100 user
- Keyboard / format
- Desktop module without keyboard, 220 x 210 x 44 mm
- Outputs
- OUTPUT L and R (RCA), headphones (mini jack); inputs: A/D INPUT (stereo jack) and INPUT L/R (RCA)
- MIDI
- MIDI IN-A, MIDI IN-B, MIDI OUT, MIDI THRU, TO HOST serial port (RS-232C/RS-422)
Known issues and maintenance
A lithium backup battery keeps internal data; Battery Low! means Yamaha service must replace it. Multi settings are not saved in the unit and must be kept with Dump Out.
Sources
to be verifiedThese notes have not been checked against the sources yet. Corrections are welcome in the comments.
- Yamaha MU90 Owner's Manual (1998 edition) ↗ — Says the MU90R manual and data booklet apply, lists the differences (p. 4); controls pp. 7-9; specifications pp. 10-11; MU90 MIDI chart dated 27 July 1998
- Yamaha MU90R Sound List & MIDI Data ↗ — MIDI data format pp. 18-22: XG, MU80 native and MU90/MU90R native bulk dumps and requests
- Yamaha MU90R Owner's Manual ↗ — Device Number p. 46, Receive System Exclusive p. 117, Dump Interval p. 118, Dump Out pp. 119-122
- Christopher Holder, Yamaha MU90R, Sound On Sound, May 1997 ↗ — Review of the rack model; context only
Sign in to write a comment.
Comments
0