Yamaha S30
The Yamaha S30 is a 61-key synthesizer from 2000 with initial touch and aftertouch. It uses Yamaha's AWM2 sample-based engine with 64-note polyphony and voices of up to four Elements drawn from 24 MB of wave ROM, each shaped by a multi-mode filter. It holds 256 preset and 128 user normal voices, drum voices and 128 user performances of up to 17 parts, with more on a SmartMedia card. One slot takes a Modular Synthesis Plug-in Board for extra synthesis engines. An arpeggiator, real-time knobs and control sliders, a four-zone master keyboard mode and SMF playback from the card complete the instrument. The S30 sends its current voice or current performance as a System Exclusive bulk dump from the Job menu, and it answers dump requests addressed to the system, voice and performance blocks. Reception depends on the Receive Bulk switch and on the MIDI device number. There is no panel command to dump the whole memory; complete backups are saved on the memory card.
SysEx messages
0 filesThis instrument is still waiting for its first SysEx.
If you own one, or can recover a dump from an old disk or backup, upload it here: every message helps the library and the community grow.
Upload a SysExSysEx guide
- Manufacturer ID
- 43
- Model ID
- 64
- Suggested delay between messages
- 10 ms
Receiving a dump
1. Enter Utility Mode and open the MIDI Ch screen. 2. Set DevNo to the device number used by the sender (1-16), or to all. 3. On the MIDI Sw screen set RcvBulk to on (protect blocks reception).
Sending a dump from the instrument
1. In Utility Mode set DevNo to a number (not off) that matches the receiver. 2. In Voice Play Mode select the voice, press JOB and turn the PAGE knob to the 4th screen, VCE Bulk Dump. 3. Press ENTER, then INC/YES. For a performance, do the same in Performance Play Mode with the 4th Job screen, PFM Bulk Dump.
Requesting a dump
The Data List documents a dump request F0 43 2n 64 ah am al F7, where the address comes from the MIDI Data Table. To request one voice or one performance, use the address of its Bulk Header block.
SysEx pitfalls
Transfers fail if the device number is off or does not match, and reception is refused while RcvBulk is set to protect. Each block carries a checksum. Voice and performance blocks may arrive in any order, but inserting a different block in the middle invalidates the transfer. With the Yamaha Voice Editor the dump interval must be 10 ms or more. XG System On takes about 170 ms.
Source: Yamaha S30 Data List, MIDI Data Format pp. 25-29; Owner's Manual pp. 101, 124, 130, 147 ↗
Specifications
- Synthesis
- AWM2 sample-based synthesis; Modular Synthesis Plug-in System for 1 optional board
- Polyphony
- 64 notes (AWM2), plus the polyphony of an installed Plug-in Board
- Multitimbrality
- 17 parts: 16 voice parts and a Plug-in part
- Oscillators
- Up to 4 Elements per voice from 24 MB wave ROM
- Filter
- Per-Element multi-mode filter, including LPF24D, LPF24A, LPF18, LPF18S, LPF12, LPF6, HPF24D, HPF12, band-pass and band-eliminate types
- Memory
- 256 preset and 128 user normal voices, 8 preset and 2 user drum voices, 128 user performances; more voices and performances on memory card
- Keyboard / format
- 61 keys, initial touch and aftertouch
- Outputs
- Output L/Mono and R, phones
- MIDI
- MIDI In, Out, Thru; To Host computer port
Known issues and maintenance
When the internal backup battery runs low the display shows Change internal battery.
Sources
to be verifiedThese notes have not been checked against the sources yet. Corrections are welcome in the comments.
- Yamaha S30 Data List (2000) ↗ — MIDI data format pp. 25-29, bulk dump blocks, MIDI data table pp. 29-36, implementation charts dated 15 February 2000
- Yamaha S30 Owner's Manual (2000) ↗ — Polyphony p. 28, Voice and Performance Bulk Dump jobs pp. 101 and 124, Utility MIDI p. 130, messages, troubleshooting p. 147, specifications p. 148
Sign in to write a comment.
Comments
0