#916 · Data Dump Request
CZ-1000 Current Voice-Channel 2
The Casio CZ-101 is a small digital synthesizer with 49 mini keys, released in November 1984 together with the full-size CZ-1000. Casio presents it as the instrument that introduced its newly developed Phase Distortion (PD) sound source. Each voice has two lines, and each line runs through a DCO, a DCW block that shapes the waveform much as a filter would, and a DCA, all with eight-step envelopes. It plays eight notes with one-line tones and four with two-line tones. Reviewers in 1985 were struck by the price: In Tune called it 'undoubtedly a Class A bargain' at GBP 395. It runs on six D-size batteries, which also keep the memory alive, and has strap buttons for playing standing up. The memory holds 16 preset tones and 16 internal tones, with 16 more on an optional RAM cartridge. Tone data travels over MIDI as System Exclusive. Casio's CZ-1 manual describes loading the 16 preset and 16 internal tones of a CZ-101 into a CZ-1 and saving 16 tones back into the CZ-101's internal memory. According to a 1995 retrospective in The Mix, a transfer cannot be started from the CZ-101's own panel.
Sign in to upload or commentIf you own one, or can recover a dump from an old disk or backup, upload it here: every message helps the library and the community grow.
Upload a SysExRelated models: CZ-1CZ-1000CZ-3000CZ-5000
The CZ-1 operation manual describes tone data exchange over MIDI with the other CZ models.
The CZ-101 documentation read gives no request procedure. Casio's CZ-1 manual shows the data being pulled by the other instrument: its MIDI LOAD command reads the CZ-101's 16 preset and 16 internal tones, and its MIDI SAVE command writes 16 tones into the CZ-101's internal memory.
A transfer cannot be started from the CZ-101 front panel (The Mix, March 1995): a computer or another CZ has to ask for the data. Sound On Sound (June 1989) notes that most Casio synthesizers use SysEx with handshaking, so dump utilities that cannot handshake do not work with them. The byte format was not available in any Casio document that could be read.
Source: Casio CZ-1 Operation Manual, viewer pp. 57 and 62-64 (tone data exchange with the CZ-1000/CZ-101)
Memory backup. There is no separate backup battery: the six D-size batteries that power the instrument also keep the internal memory. Replace all six together when the power indicator starts to flash. Reset. After fitting or replacing batteries the manual says to press the recessed P button with the power on; this restores the factory internal tones. Protect switch. The memory protect switch on the back must be OFF for write, save and load, and should be set back to ON afterwards. Age. A 1995 retrospective in The Mix warns that old batteries can leak and damage the unit and that the instrument is fussy about its power supply.
These notes have not been checked against the sources yet. Corrections are welcome in the comments.
Sign in to write a comment.
Comments
0