#916 · Data Dump Request
CZ-1000 Current Voice-Channel 2
The Casio CZ-5000 is a 61-key digital synthesizer with a built-in eight-track sequencer, which reached the market in 1985. It uses Casio's Phase Distortion (PD) sound source: a voice has one or two lines, each with a DCO offering 33 waveforms, a DCW block that plays the part of a filter and a DCA, all with eight-step envelopes. It plays 16 notes with one-line voices and 8 with two-line voices, and has Tone Mix and Key Split modes and a stereo chorus. The keyboard is not touch sensitive. The sequencer records up to 3,500 notes in real time or 7,000 entered manually, and each track can play its own sound. International Musician found the instrument 'astonishingly good value for money' at GBP 955, while reviewers regretted the single stereo output. It holds 32 preset and 32 memory voices; a RAM cartridge or a cassette recorder stores more. Voices also travel over MIDI as System Exclusive. Casio's CZ-1 manual describes saving 32 CZ-1 tones into the CZ-5000's memory bank and loading the CZ-5000's 32 preset and 32 memory voices into a CZ-1, started from the CZ-1. Tone names, velocity and level settings are not part of the exchange.
Sign in to upload or commentIf you own one, or can recover a dump from an old disk or backup, upload it here: every message helps the library and the community grow.
Upload a SysExRelated models: CZ-1CZ-1000CZ-101CZ-3000
The CZ-1 operation manual describes tone data exchange over MIDI with the other CZ models.
1. Connect the sender's MIDI OUT to the CZ-5000's MIDI IN (and the CZ-5000's MIDI OUT to the sender's MIDI IN for two-way transfers). 2. Press the MIDI key and set the receive channel (CH) to the sender's channel. 3. Set PRG to ENA. 4. Set the PROTECT switch on the rear panel to OFF. 5. Start the transfer from the other instrument. When it has finished, set PROTECT back to ON.
The CZ-5000 answers requests from the other device. Casio's CZ-1 manual defines a send request (the instrument sends the data of one tone for the given memory number) and a receive request (it stores the tone data that follows into the given memory number). From a CZ-1, MIDI LOAD with SUSTAIN held reads the CZ-5000's 32 preset and 32 memory voices; MIDI SAVE writes 32 tones into its memory bank A1-D8.
No front-panel dump command was found for the CZ-5000: transfers are started by the other device. In an exchange with a CZ-1, tone names and the CZ-1's velocity and level settings are not transferred, so a tone may sound different on the two instruments. The byte format was not available.
Source: Casio CZ-1 Operation Manual, viewer pp. 54, 57 and 62-63; Casio CZ-5000 Operation Manual, viewer pp. 11 and 50-51
Backup batteries. The memory is kept by three D-size dry cells with a stated life of about one year, so they have to be renewed regularly. Protect switch. With the rear PROTECT switch ON, nothing can be written to memory or loaded from a cartridge or cassette. The manual says to leave it ON and switch it OFF only to write or load. Tape. Voices and sequencer data can be saved to a cassette recorder through the MT terminal; the manual gives a VERIFY procedure to check the recording. Limits noted by reviewers in 1985: no touch sensitivity, one stereo output for all sequencer tracks, no auto-correction or looping in the sequencer.
These notes have not been checked against the sources yet. Corrections are welcome in the comments.
Sign in to write a comment.
Comments
0